Single-shaft shredder for volume reduction with particle size control in a single step (one step), without the need for additional equipment in the line.
One Step Concept
The RAPTOR shreds and controls particle size within the same machine through a replaceable bottom screen.
- Reduces the number of machines in the line and simplifies the layout
- Final particle size is defined by the installed screen: range of 20 to 120 mm
- 845 mm diameter rotor operating at low speed (~85 rpm) generates fewer fines and less wear
Applications
- Tire chip reduction
- Industrial rubber
- Heterogeneous industrial waste
- RDF/SRF fraction preparation
- Bulky materials after pre-processing
Documented Performance
| Input Material | Output | Configuration | Indicative Capacity* |
|---|---|---|---|
| Tire chips ~70 mm | ~20 mm | RAPTOR 2000 S50 - 2x200 HP | ~2.5 t/h |
*Actual capacity depends on density, moisture, composition, and maximum input dimension.
Rotor Specifications
| Parameter | Specification |
|---|---|
| Diameter | 845 mm |
| Available lengths | 2000 mm / 3000 mm |
The large diameter provides greater moment of inertia, resulting in cutting stability and lower current peaks.
Power & Speed
| Model | Available Power Ratings |
|---|---|
| RAPTOR 2000 | 1x200 HP |
| RAPTOR 3000 | 1x200 HP / 2x200 HP / 2x250 HP |
Available speeds: 35 / 65 / 95 rpm
Electrical System & Controls
| Component | Specification |
|---|---|
| Control | Industrial PLC |
| Drive | Variable frequency drive |
| Power supply | 380 / 440 V |
| Protection | Automatic reversal |
| Hydraulic unit | 20 HP (model dependent) |
Automatic reversal protects against jamming and reduces manual interventions.
Maintenance
- Bolt-on replaceable blades (no welding required)
- Hydraulic access to the screen cradle
- Reinforced structural base for heavy industrial environments
Consolidated Technical Specifications
| Parameter | RAPTOR 2000 | RAPTOR 2800 |
|---|---|---|
| Rotor Diameter | 800 mm | 800 mm |
| Rotor Length | 2000 mm | 2800 mm |
| Installed Power | 2x125 to 2x250 HP | 2x125 to 2x250 HP |
| Available Screens | 20-120 mm | 20-120 mm |
| Typical Speed | ~85 rpm | ~85 rpm |
| Control | PLC + VFD | PLC + VFD |
| Power Supply | 380/440 V | 380/440 V |
Factors That Determine Actual Capacity
- Material density
- Moisture content
- Composition
- Maximum input dimension
- Selected screen aperture
